Main menu
You are here
QJackCtl v0.3.13.9 and above doesn't "remember" settings
27 June, 2015 - 15:58 — babarosa
Dear Rui!
QJackCtl v0.3.13.9 and above always runs with 48000 Hz although I set it to 44100Hz and QJackCtl.conf shows the value 44100. Additionally QJackCtl starts automatically Jack although the setting in the tab is not activated.
v0.3.13.8 works fine.
Greetings, Michael
Forums:
re. QJackCtl v0.3.13.9 and above doesn't "remember" settings
that is totally weird! o.O
are you sure don't have conflicting configurations, one system wide (/etc/xdg/rncbc.org/QjackCtl.conf) and another user local (~/.config/rncbc.org/QjackCtl.conf) ?
are you sure you have the correct configuration as last you've run qjackctl? are you switching different users or even machines ?
byee
QJackCtl v0.3.13.9 and above doesn't "remember" settings
;-) It is even more wired:
I am running two machines with the same setup (Xub 14.04., same kernel, jackd2, ...), one for movies and music listening. On this machine qjackctl v9+ works fine. The other, my audio studio machine, shows the mentioned behaviour. So I excuse for the noiseagain and will check (I guess I have to exchange the problem in front of the screen).
Greetings, Michael
re. sample-rate stickiness...
np.
also make a side-note that some sound-card devices do stick to a 48000 sample-rate no matter what you tell from qjackctl / jackd (especially if down to -r44100)..
hth.
cheers
sample-rate stickiness...
Hi Rui,
after deinstalling, rebooting and reinstalling everything is fine again.
Thank you, Michael
Add new comment