Forums
Dear Rui!
QJackCtl v0.3.13.9 and above always runs with 48000 Hz although I set it to 44100Hz and QJackCtl.conf shows the value 44100. Additionally QJackCtl starts automatically Jack although the setting in the tab is not activated.
v0.3.13.8 works fine.
Greetings, Michael
re. QJackCtl v0.3.13.9 and above doesn't "remember" settings
that is totally weird! o.O
are you sure don't have conflicting configurations, one system wide (/etc/xdg/rncbc.org/QjackCtl.conf) and another user local (~/.config/rncbc.org/QjackCtl.conf) ?
are you sure you have the correct configuration as last you've run qjackctl? are you switching different users or even machines ?
byee
QJackCtl v0.3.13.9 and above doesn't "remember" settings
;-) It is even more wired:
I am running two machines with the same setup (Xub 14.04., same kernel, jackd2, ...), one for movies and music listening. On this machine qjackctl v9+ works fine. The other, my audio studio machine, shows the mentioned behaviour. So I excuse for the noiseagain and will check (I guess I have to exchange the problem in front of the screen).
Greetings, Michael
re. sample-rate stickiness...
np.
also make a side-note that some sound-card devices do stick to a 48000 sample-rate no matter what you tell from qjackctl / jackd (especially if down to -r44100)..
hth.
cheers
sample-rate stickiness...
Hi Rui,
after deinstalling, rebooting and reinstalling everything is fine again.
Thank you, Michael
Add new comment