Main menu
You are here
Input output settings
25 October, 2023 - 18:55 — Almocotarx751
Hello everyone, I'm new here and I installed Qtractor on Raspberry Pi, I didn't understand how to set the input and output devices, I have a sound card connected to the Raspberry that I would like to set as an input device, I currently tried to add an audio track empty but I don't see the signal arriving, usually in DAWs there is a colored bar that goes up and down, I assume that the problem is to be found in the fact that I haven't set the input device, can anyone help me? Thank you.
Forums:
re. Input output settings
hi,
you know you need either genuine-jackd(bus) or pipewire-jack up and running, don't you?
seeya
Hi, no I don't know this
Hi, no I don't know this aspect, what are the drivers? How do I install them?
QJackCtl
Check to see if you have QJackCtl installed.
In it you can configure the input and output devices.
https://qjackctl.sourceforge.io/image/qjackctlSetupForm6.png
QJackCtl web:
https://qjackctl.sourceforge.io/qjackctl-index.html#Intro
Hi qjackctl is already
Hi qjackctl is already installed but how do I set input and output? What is the route?
Tutorial and manual
I think that at this point in this tutorial it is clearly shown, although I recommend that you watch it in its entirety.
https://youtu.be/h7tbtGotjTU?feature=shared&t=51
I also recommend you see the official documentation, in this case point 2.6 and especially 2.7.
https://www.qtractor.org/doc/Manual%20-%202%20Installing%20and%20Configu...
It doesn't hurt to read the entire manual, I'll give you the pdf version to make it easier for you.
https://sourceforge.net/projects/qtractor/files/qtractor/docs/qtractor-m...
Add new comment