at some point, Qtractor writes it somewhere. So I must be able to populate this list myself somehow, programatically?
on the a. case, talking about native .synthv1 preset files, that's not and never were a qtractor job whatsoever--it is synthv1 actually who does it on its own way. you should know that, once you load a preset file from the main synthv1 GUI it stays there mapped on drop-down list from that moment on. again, it doesn't matter if you're on the LV2 plugin version or the JACK stand-alone client, they both refer to the same configuration file that is ~/.config/rncbc.org/synthv1.conf.
of course, if you dare and are brave enough, you can try editing the preset map section that is stored in the .conf file. at your own risk and benefit. ;)
at some point, Qtractor writes it somewhere. So I must be able to populate this list myself somehow, programatically?
on the a. case, talking about native .synthv1 preset files, that's not and never were a qtractor job whatsoever--it is synthv1 actually who does it on its own way. you should know that, once you load a preset file from the main synthv1 GUI it stays there mapped on drop-down list from that moment on. again, it doesn't matter if you're on the LV2 plugin version or the JACK stand-alone client, they both refer to the same configuration file that is
~/.config/rncbc.org/synthv1.conf
.of course, if you dare and are brave enough, you can try editing the preset map section that is stored in the .conf file. at your own risk and benefit. ;)
cheers