maybe the solution is just simple as this: moving or copying an aux-send must always reset target bus name to "(none)".
get it? :)
iirc. this was fixed to the current state of matters recently during the xaudio-bus-aux sprints, or sort of, but now I reckon that's probably a (serious) mistake. EDIT: it wasn't, sorry about that; but the writing is on the wall: copying/moving aux-sends must always reset to "(none)", nevertheless
maybe the solution is just simple as this: moving or copying an aux-send must always reset target bus name to "(none)".
get it? :)
iirc. this was fixed to the current state of matters recently during the xaudio-bus-aux sprints, or sort of, but now I reckon that's probably a (serious) mistake. EDIT: it wasn't, sorry about that; but the writing is on the wall: copying/moving aux-sends must always reset to "(none)", nevertheless
what you think?