maybe the solution is just simple as this: moving or copying an aux-send must always reset target bus name to "(none)".
get it? :)
iirc. this was fixed to the current state of matters recently during the xaudio-bus-aux sprints, or sort of, but now I reckon that's probably a (serious) mistake. EDIT: it wasn't, sorry about that; but the writing is on the wall: copying/moving aux-sends must always reset to "(none)", nevertheless
what you think?
Copyright (C) 2006-2024 rncbc aka Rui Nuno Capela. All rights reserved.
Powered by Drupal
Recent comments
1 hour 34 min ago
2 hours 51 min ago
4 hours 55 min ago
5 hours 51 sec ago
5 hours 21 min ago
5 hours 48 min ago
1 day 2 hours ago
1 day 3 hours ago
1 day 4 hours ago
1 day 4 hours ago